Drilling Masonry

SDS Plus drills fit rotary hammer drills with an SDS Plus chuck and are the most common choice for masonry work.

Designed for fast, efficient drilling in brick, block, and general masonry, they use hammer action to break material while the carbide tip cuts cleanly. Ideal for everyday fixings, anchors, and installation work.

Designed for combi and rotary drills with a standard 3-jaw chuck.

Profi Masonry drills are the everyday choice for brick and block. Extreme Concrete drills have the same tungsten carbide tip with an SDS-style spiral on a round shank – they clear dust and drill like an SDS bit in a standard hammer drill.

Use with or without hammer mode depending on the material.

Built for heavy-duty drilling with SDS Max rotary hammer drills. The 18 mm shank will not fit an SDS Plus machine.

SDS Max drills deliver higher impact energy, making them ideal for large-diameter holes, deep drilling, and tougher masonry or structural concrete. Best suited to professional and site-based applications.

Tungsten Carbide Tipped core drills remove a full core of material for fast, clean holes.

Ideal for brick, block, and concrete when installing pipes, vents, ducting, or cable runs. Designed for use with a compatible pilot drill and machine for controlled cutting.

Designed for controlled handheld drilling of larger holes without a water feed

Dry diamond core drills are ideal for brick and block, commonly used for waste pipes, vents, and cable routes. Used at controlled speed with cooling breaks, they deliver clean, accurate results.

Designed for precision drilling in concrete and reinforced concrete using a water feed.

Wet diamond core drills reduce heat, dust, and cracking, producing clean, accurate holes in dense or structural materials. Typically used with rigs or specialist drilling equipment.